<span id="hhv12"><video id="hhv12"></video></span>
    <var id="hhv12"><tr id="hhv12"></tr></var>

      <legend id="hhv12"></legend>
      <ol id="hhv12"></ol>

      Shenzhen Grande Electronic Linkedin Page
      Shenzhen Grande Electronic Co., Ltd logo
      E-mail us for a Quote:
      sales88@greattong.com
      Call us now:
      +86-755-83261869

      Technical Article


      When do you set different temperatures for the heating elements?

      Time:2017-09-22 17:44:03 Click:

      reflow with through-hole connector

      In most situations, the thermal setpoints of a reflow oven are the same for both the Top and Bottom heating elements in the same zone. But there are special cases where it is necessary to apply different temperature settings to the TOP and BOTTOM elements.


      The SMT process engineer should review the specific board requirements to determine the correct settings. In general, here are some guidelines for setting heating element temperatures: 

      ? If there are through hole (TH) components on the board, and you want to reflow them with SMT components together, you may want to consider increasing the bottom element’s temperature because the TH components will block hot air circulation on the top side, preventing the the pads under TH components from receiving enough heat to make a good soldering joint. 
      ? Most TH connector housings are made from plastic which will melt once the temperature gets too high. The process engineer must perform a test first and review the result.
      ? If there are big SMT components such as inductors and aluminum capacitors on board, you will also need to consider setting different temperatures for the same reason as TH connectors. The engineer needs to collect thermal data of a particular board application and adjust thermal profile several times in order to determine the correct temperatures. 
      ? If there are components on both sides of a board, it is possible to set different temperatures as well.

      Finally, the process engineer must check and optimize the thermal profile for every particular board. Quality engineers should also involved in order to inspect the solder joint. An x-ray inspection machine may be utilized for further analysis. 

      Previous:SMT: The Application of the Pin-in-Paste Reflow Process

      Next:Why does Shenzhen Grande Use a 10 Zone Force air convection reflow oven?


      Request an Official Quote

      Questions

      E-MAIL

      File Upload

      Upload a list of files

        Please upload your Gerber files and BOM. You can upload an unlimited number of files as long as the total size of all files does not exceed 20 MB. To ensure you receive your official quote in less than 24 hours, please include the quantity of circuit boards for which you would like a quote.

        If you require that we sign a Non-Disclosure Agreement (NDA), please send it to us prior to sending your files and we will be happy to accommodate.

         
        Home About Us Services Quality Pb-Free News Contact Us


        Copyright ® 2017,Shenzhen Grande Electronic Co., Ltd. All Rights Reserved. 中文站 Sitemap

        18禁美女裸体无遮挡免费观看